Simon Says Stamp Birthday Whirl Medallion

Hello, Hello! Thanks so much for stopping by! I’m back today with a project featuring the new Whirl Medallion from Simon’s latest release, Be Bold. If you’ve been around here for a little while, you probably know that I like creating backgrounds with single dies, and today’s project does just that. So, let’s go run through the deets for this one!

Main Products:

I began this project by cutting a bunch of the SSS Whirl Medallions from gold cardstock. Once I had enough of the medallions, I grabbed a panel of Neenah 110lb cardstock and started playing around with the placement. I knew that I wanted to cover the whole panel, so I began in the middle of the panel.

I adhered the first medallion with liquid glue, and worked my way outward from there. Once all of the medallions were placed, I trimmed off the excess. This panel was then adhered to a black panel with foam tape for contrast. I used this Happy Birthday sentiment, which is from the SSS Birthday Basics set, and stamped that using VersaMark Ink and heat setting it with Ranger Princess Gold Embossing Powder.

I used the coordinating die to cut out the sentiment, along with two additional cuts and glued all of those together for a stacked look. The sentiment was then adhered in the center of the card with SSS 3D Foam Strips, and the entire panel was adhered to the card base.

Pretty simple card for today! Die cutting is my jam, and I love creating backgrounds with a single die or with smaller dies. I hope you enjoyed this project, and I hope it inspires you to get creative with your dies! Don’t forget to check out the entire Be Bold release over on Simon’s website. Thanks again for stopping by, and I hope you have a wonderful day!

Other Products:

* Affiliate links used at no cost to you. Thanks so much for your support!

Latest Posts

Latest Instagram Posts

Leave a comment